Custom Safety Products, Inc.

Maintenance

A clean surface is the optimum surface. When it becomes necessary to clean the safety pads, any of the following methods can be used:

• steam, if available
• strong detergent with scrub brushes
• non-flammable solvent which will cut oil and grease

Resurfacing with Non-Skid Coating

When the non-skid surface has been worn down, it should be reapplied with a pre-measured one-gallon kit available from Custom Safety Products, Inc. This operation can be done on the rig by the rig personnel.

Recoat Procedure

1. Remove Safety Pad II FR from rotary table.
2. Clean per instructions above.
3. Roughen surface lightly with wire brushes or grinder
4. Mix Primer 450, Parts A & B.
5. Apply evenly with short-nap paint roller or conventional spray gun.
6. Allow to dry 45 minutes.
7. Mix CS-200 non-skid parts A & B with mixer blade in 1/4" or 3/8" drill motor for a full eight minutes.
8. Apply evenly with short-nap roller (included in kit) or hopper gun and let cure overnight.
9. Place back on rotary table.

 

Non-Skid Resurfacing Kit

When necessary (normally once a year), contact Custom Safety Products, Inc. for a non-skid resurfacing kit. The kit contains instructions, non-skid material, primer, mixer blade, roller and pan. Contact Custom Safety Products for price and availability. No other product should be used to resurface a Custom Safety Products pad.

---